Guidance For Ball Joint Replacement

An automobile bears some spherical parts which connect the control arms to the steering knuckles; these are called as the ball joints. You need to seek the advice of online information with regards to ball joint replacement. They are vital between the wheels and for the suspension of an automobile. Lack of lubrication and oiling may result in its urgent replacement, and hence the necessity of ball joint replacement.

Before going ahead with the replacement procedure, like in all the other automobile part’s repair process, some safety measures are must.

• The vehicle should be lifted up using a jack.
• The hand brakes or the parking brakes need to be engaged.
• Lying under the vehicle for any kind of repair should be avoided, as there always is a risk of jack malfunctioning.

The reinstallation procedure requires a rubber boot, grease fitting, castellated nut, and cotter pin. Before going ahead with ball joint replacement procedure, the part should be washed to remove dirt and grease. Instead of an air chisel, a drill can also be installed.

1. Pull out the ball joint by removing the four top bolts by using a nine by sixteen inches socket and wrench.
2. This should be followed by removal of the cotter pin and the slotted nut from the lower bolt, thereby tossing out the old pin. Using a separator, hammer heavily till the ball joint comes out.
3. Clean the grease and debris clutter around the hole in the hub and the upper control arm.
4. Put a new ball joint on the empty space in the upper control arm.
5. It should be bolted firstly to the hub and later to the A arm.
6. Tighten the slotted nut by hands.
7. Tighten the nuts and the bolts, and insert a new cotter pin.
8. Install back the wheels.

A car has a single joint per slide. It is therefore advised to buy only the specific brand parts, manufactured by a reputed company.